Kärcher K 5.55 Jubilee Mode D'emploi page 11

Operation
Description of the Appliance
When unpacking the product, make sure that no
accessories are missing and that none of the
package contents have been damaged. If you
detect any transport damages please contact
your dealer.
Illustrations on Page 2
1 Transport handle
2 Storage for spray lance
3 Mains cable with mains plug
4 Connection for water supply with filter
5 Coupling element for water connection
6 High pressure hose
7 High pressure connection
8 Appliance switch "0/OFF"/ „I/ON"
9 Storage for high-pressure hose
10 Detergent Tank
11 Suction hose for detergent
12 Storage for trigger gun
13 Lock trigger gun
14 Trigger gun
15 Spray lance with pressure regulation (Vario
Power)
16 Spray lance with Dirtblaster
Special accessories
Special accessories expand the possibilities of
using your appliance. Please contact your
KÄRCHER dealer for further information.
Before Startup
Illustration
Mount loose parts delivered with appliance prior
to start-up.
Illustration
Connect high pressure hose to trigger gun.
Push the high pressure hose into the trigger
gun until it locks audibly.
Note: Make sure the connection nipple is
aligned correctly.
Check the secure connection by pulling on
the high-pressure hose.
Water supply
According to the applicable regula-
tions, the appliance must never be
used on the drinking water supply with-
out a system separator. Use a suitable
system separator manufactured by KÄRCHER;
or, as an alternative, a system separator as per
EN 12729 Type BA. Water flowing through a sys-
tem separator is considered non-drinkable.
Note: Impurities in the water can damage the
high-pressure pump and accessories. For pro-
tection, the use of the KÄRCHER water filter (op-
tional accessory, order no. 4.730-059) is
recommended.
Water supply from mains
Observe regulations of water supplier.
For connection values, see type plate/technical
data.
Use a fibre-reinforced water hose (not in-
cluded) with a standard coupling. (Minimum
diameter 1/2 inch (13 mm), minimum length
7.5 m).
Screw the coupling unit (supplied) to the wa-
ter connection on the appliance.
Push the water supply hose onto the cou-
pling unit, then connect it to the water supply.
Drawing in water from open reservoirs
This high-pressure cleaner is suited to work with
the KÄRCHER suction hose with backflow valve
(Optional accessory, order no. 4.440-238) to
draw in surface water, e.g. from water butts or
ponds (see specifications for max. suction
height).
Fill the KÄRCHER suction hose with back-
flow valve with water, screw to water supply
and hang into he water butt.
Separate the high pressure hose from the
high pressure connection of the appliance.
Switch the appliance on (I/ON) for a max. of
2 minutes and wait until the water exits the
high-pressure connection without bubbles.
Turn off the appliance "0/OFF".
English 11
5
Deutsch