Time And Date Adjustment; Rf Installation - Watts BT-DPRF-02 Guide D'utilisation

2.2

Time and Date adjustment

Each time a value blinks, you can adjust it with the (-) and
(+) keys, once the value is chosen, validate it with the (OK)
key. The thermostat will jump automatically to the next
value.
Note: you can always come back to the previous value by
pressing the escape key (
List order of the time and date adjustments:
Time and day:
Adjustment of the hours,
Adjustment of the minutes
Adjustment of the day (1 = Monday)
Date:
Adjustment of the day number
Adjustment of the month number (01 to 12)
Adjustment of the year
Then the message "Save" and blinking green LED
appears, press (OK) to validate the adjusted time and date.
You can always reach the time and date adjustments, by
pressing and maintaining the edition ( ) key during 2
seconds in normal operating modes.
2.3

RF installation

2.3.1
- First of all to configure your thermostat with the receiver,
you must put your receiver in « RF init ». mode. (please
refer to the receiver leaflet for this, only the RF receiver of
the same range are compatibles)
- Now on the thermostat press and maintain the edition key
( ) during 5s, then the parameter « RF ini » must be
display.
The thermostat will send now the radio configuration signal
to the receiver.
With receivers
).
8