Hansgrohe PHARO Duschtempel 115 EL 40 29040 Mode D'emploi page 42

F i t t i n g a n d s e a l i n g g l a s s p a n e l s
SW 27
42
SW 4
SW 2
Fitting glass panels
Both panels are identical, but it is important that the side
with the drill holes for the eccentric discs are positioned at
the front. Slide the panel into the groove in the wall
profile, now push the glass toward the column.
When the panel is in position, adjust it so that is sits on
the shower tray. Take care not to damage the seal strip.
Push the excentric discs through the glass to the screw
sockets and secure it with 4 countersunk screws with 4
hexagonal screws M6x12.
The action of turning the excentric disc with an
open ended spanner, pushes the glass panels with
the sealing strips to the shower tray and the column.
This will also act as a seal between glass panel
and column.
Now you can tighten the hexagonal screw
with a SW4 Allen key and secure with grub screws. Fit
caps.