Eneo PTB-1008F Serie Mode D'emploi page 22

PoE (IEEE Std. 802.3af). When using a 12VDC or 24VAC power supply
please proceed as follows:
• Make sure the power is removed before the installation.
• Follow the order for applying power.
First, connect the low voltage (AC24V or DC12V), then plug the AC adapter
to AC outlets to avoid an improper reset from power jitter and a damage
from the surge voltage when no load.
To communicate with the network camera it is necessary to connect a
standard RJ-45 cable to it. Generally a cross-over cable is used for direct
connection to PC, while a direct cable is used for connection to a hub /
switch.
4a) Easy Bracket: Connect hook ⓘ
to peg ⓚ.
5a) Easy Bracket: Fix Bracket Foot ⓒ
to EASY BRACKET by using wrench
bolts through Foot mount Hole (4x)
ⓓ.
6. Set the camera's angle (Pan, Tilt, inclination).
Tilt is limited to 0°(2°) min ~ 90° max. for wall(ceiling) installation respec-
tively with reference to the ceiling when the inclination of camera module is
0°, that is, the image is aligned horizontally.
22
4b) Standard Bracket: Match Foot
mount Hole (4x) ⓓ to the drilled
position.
5b) Standard Bracket: Fix the bracket
by using Wall fixing screws.
Pan is limited to +/- 90°.