GEZE TS 5000 L-ISM VPK Instructions De Montage page 11

TS 5000 L-ISM VPK
Loosen clamping screw (1.).
X
Thread wire rope with wire rope redirection into oblong hole (2.).
X
Thread past the clamping screw and guide out of the oblong hole (3.).
X
Tension wire rope so that the IS valve (fig. 6.6.1) at door closer on moving-leaf end cannot be operated (4.).
X
Tighten clamping screw (5.).
X
Mount trigger lever (6.).
X
Shorten wire rope to an excess of 30–50 mm to the outer edge of the guide rail (7.).
X
6.4 Mount sliding lever to fixed leaf and connect with sliding block
In the state of delivery the door edge prevents correct fitting of the sliding lever on the door closer.
The notch in the hexagon of the door closer must be aligned with the sliding lever.
Close closing-time valve (1.).
X
SW5
Mounting and fixing
Fig.: 6.3.2
Fig.: 6.4.1
GB 5