Publicité
FAILURE TO OBSERVE THESE WARNINGS COULD RESULT IN INJURY
IMPORTANT! BEFORE USE...
Air may become trapped in the hydraulic system during transit.
To purge air:
1. Open release valve by turning knob counterclockwise.
2. Pump foot pedal rapidly 4 full strokes. This will expel air that may
have entered oil passages during transit.
3. Close release valve by turning knob clockwise.
4. If lift arm raises, jack is ready for use. If not, repeat this
procedure.
OPERATING INSTRUCTIONS
iMPOrTanT: Before attempting to raise a vehicle, check vehicle
service manual for recommended lifting surfaces.
1. To raise load: Close release valve tightly by turning knob
clockwise. Position jack under load so that saddle will contact
load firmly and load is centered so it cannot slip. Operate foot
pedal until saddle approaches the load. Then unlock the handle
by pulling the handle lever up and to the right. Pump the handle
to lift the load. Once again check to see that the saddle is
correctly positioned. Place jack stands of appropriate capacity
under the vehicle. DO NOT CRAWL UNDER VEHICLE WHILE
LIFTING VEHICLE OR PLACING OR REMOVING JACK STANDS!
Place jack stands at vehicle manufacturer's recommended lift
areas that provide stable support for the raised vehicle. Slowly
pull handle level to the left to lower the vehicle onto the jack
stands. Lower the vehicle slowly so as not to shock load the
jack stands. Once repairs are completed, raise vehicle enough to
remove jack stands.
2. To lower load: Turn knob counterclockwise very slowly. When
release valve is opened, saddle and load will be lowered.
caUTiOn: Keep hands or feet away from the hinge mechanism of
the jack.
INSPECTION
Visual inspection should be made before each use of the service
jack, checking for leaking hydraulic fluid and damaged, loose or
missing parts. Each jack must be inspected by a manufacturer's
repair facility immediately, if accidentally subjected to an abnormal
load or shock. Any jack which appears to be damaged in any way, is
found to be badly worn, or operates abnormally MUST BE REMOVED
FROM SERVICE until necessary repairs are made by a manufacturer's
authorized repair facility. It is recommended that an annual inspection
of the jack be made by a manufacturer's authorized repair facility and
that any defective parts, decals or warning labels be replaced with
manufacturer's specified parts. A list of authorized repair facilities is
available from the manufacturer.
MSJ5
MSJ5 5 TON SERVICE JACK
OWNER/USER RESPONSIBILITY
The owner and/or user must have an understanding of the
manufacturer's operating instructions and warnings before using
the service jack. Personnel involved in the use and operation of
equipment shall be careful, competent, trained, and qualified in the
safe operation of the equipment and its proper use when servicing
motor vehicles and their components. Warning information should be
emphasized and understood. If the operator is not fluent in English,
the manufacturer's instructions and warnings shall be read to and
discussed with the operator in the operator's native language by the
purchaser/owner, making sure that the operator comprehends its
contents.
Owner and/or user must study and maintain for future reference
the manufacturer's instructions and pertinent warning information.
Owner and/or user is responsible for keeping all warning labels
and instruction manuals legible and intact. Replacement labels and
literature are available from the manufacturer.
MAINTENANCE
All moving joints require lubrication often. Remove handle and grease
the lower end of handle where it strikes the release mechanism.
Using a grease gun, grease the lift arm pivot shaft grease fitting until
grease appears at the end of the shaft. Oil all lift arm linkages, front
wheels and rear casters.
ASSEMBLY INSTRUCTIONS
1. This unit comes pre-assembled, except for the handle.
2. Unscrew bolt, washer and nut from handle block assembly.
3. Check all bolts for tightness before use.
Hold handle parallel with ground, slide into handle block assembly.
Screw the bolt, washer and nut back in.
Rev. 09/04/07
Publicité
