AEG Voxtel D235 Mode D'emploi page 10

10
5.5 Overview of the wireless headset (see P4)
Power / talk on/off
In idle mode: press and hold to power the wireless headset on
or off.
17
During ringing: press to answer the call.
During a call: press to end the call.
During registration: press to exit the registration mode.
Volume up / flash
During a call: press to increase the earpiece volume. Press and
18
hold to answer a second incoming call.
During ringing: press to increase the ringer volume.
Volume down
19 During a call: press to decrease the earpiece volume.
During ringing: press to decrease the ringer volume.
Note:
If the wireless headset is not registered, press and hold volume up / flash
key together with volume down key to initiate the registration mode.
5.6 Wireless headset LED indicators
Steadily on: the wireless headset is unregistered.
Purple Flashing: the wireless headset is registered, but the base
is not available (searching or out of range).
Steadily on: when the headset is seated in the base and
fully charged.
Once the headset is successfully registered, the blue
light will flash on then off, for about three seconds at a
time, and emit a long beep.
Blue Single flashing: the wireless headset is in idle mode and
off the base.
Double flashing: the wireless headset is on a call, and if
the signal becomes weak, double beeps will be heard.
Continuously flashing: the wireless headset is ringing. A
ringing will also be heard in the earpiece.