Télécharger Imprimer la page

Beko WMY 81283 LMB3 Manuel D'utilisation page 19

Lave-linge

Publicité

Les langues disponibles

Les langues disponibles

2. Wait until the Loading Door can be opened.
3. Open the Loading Door and add or take out
the laundry.
4. Close the Loading Door.
5. Make changes in auxiliary functions,
temperature and speed settings if
necessary.
6. Press Start / Pause to operate the product.
4.3.12 Cancelling the programme
The programme is cancelled when the product
is turned off and on again. Press and hold On /
Off button for 3 seconds.
C
INFORMATION
• If you press On / Off button when
the Child Lock is enabled, the
programme will not be cancelled. You
should cancel the Child Lock first.
• If you want to open the loading door
after you have cancelled the programme
but it is not possible to open the loading
door since the water level in the product
is above the loading door opening,
then turn the Programme Selection
knob to Pump+Spin programme and
discharge the water in the product.
4.3.13 End of programme
The "Complete" light (LED) will turn on when
the programme is over.
If you do not press any button for 10 minutes,
the product will turn off automatically. Display
and all indicators are turned off.
Completed programme steps will be displayed
if you On / Off.
4.3.14 Energy saving mode
If no action is taken for 2 minutes after turning
on the product with On / Off button or after
the chosen programme ends, the product will
switch to energy saving mode automatically.
The brightness of the indicator lights will
decrease. This display will be closed completely
if programme time display is available.
If you turn the programme knob or touch any
button, the lights will switch back to previous
position.
C
INFORMATION
• This is a feature of this product,
and not an error.
19 / EN
4.4 Maintenance and cleaning
Service life of product extends and frequently
experienced problems will be reduced if it is
cleaned at regular intervals.
4.4.1 Cleaning the detergent drawer
Lift the rear part of the siphon to remove it as
illustrated.
If more than normal amount of water and
softener mixture starts to gather in the softener
compartment, the siphon must be cleaned.
1 Press the dotted point on the siphon in the
softener compartment and pull towards you
until the compartment is removed from the
machine.
2. Wash the detergent drawer and the
siphon with plenty of lukewarm water
in a washbasin. In order to prevent the
residues to contact your skin, clean it with
an appropriate brush by wearing a pair of
gloves.
3 Insert the drawer back into its place after
cleaning and make sure that it is seated
well.
4.4.2 Cleaning the loading
door and the drum
For products with drum cleaning programme,
please see Operating the product -
Programmes.
C
INFORMATION
• Repeat Drum Cleaning process
in every 2 months.
• Use an detergent / anti-limescale
suitable for the washing machines.
After every washing
make sure that no foreign
substance is left in the
drum.
If the holes on the bellow shown in the figure is
blocked, open the holes using a toothpick.
Washing Machine / User's Manual
Clean the detergent
drawer at regular intervals
(every 4-5 washing cycles)
as shown below in order
to prevent accumulation of
powder detergent in time.

Publicité

loading