Fagor IF-4 S Manuel D'utilisation page 17

elapsed it will return to the power setting
selected.
Recommendations: After selecting power
setting , if no fi nal working power setting is
chosen the ring will switch off.
While is shown on the display, if you press
any power control this will cancel the function.
2.13 Child lock function: To prevent children
from changing the settings, press the
button and hold it down for 3 seconds. To
unblock it again, repeat the process.
2.14 Beeper: To deactivate the beeper, the hob
must be switched off. Press the
setting and time buttons of the lower right
ring simultaneously until
on the display. Hold the buttons down until
the digits disappear (2.14.1). To activate it
again, repeat the process.
Recommendations: You should preferably use
the cooking zones on two opposite sides.
Prevent any pans from knocking against the
glass.
Use suitable pans for induction cooling.
Use pans with a thick, fl at base.
Warnings: If you leave any objects on the
sensors, a beep will sound and the hob will
switch off.
The hob switches off automatically after an
estimated safety time has elapsed. This time will
vary depending on the power setting selected
(1 - 10 hours).
If you are boiling liquids at high power settings,
you will hear a buzzing noise. This is due to the
ring frequency coupling and it is normal.
On mixed models with radiant rings, do not
touch these zones as it could cause burns.
3
As the glass does not heat up much on
induction hobs, they are easy to clean. However,
you should clean up any spills or splashes as
soon as possible with a damp cloth or a piece
of laminated paper. For more resistant stains,
use specifi c vitro-ceramic cleaning products.
For mixed models with radiant rings, the glass
reaches a very high temperature. You should
clean it as quickly as possible, without letting
the spills dry on the glass. To clean heated up
stains, use a sponge and soapy water and a
special scraper for glass.
power
Do not use a steam cleaner.
appears
The use of abrasive cleaning products or hard
metal scouring pads for cleaning the hob can
cause surface scratches and may cause the
glass to break.
Remove any sugar stains or residues
immediately, as they could damage the hob
surface.
4
The hob does not switch on. Check it
is connected to the mains and check the
differential switches.
The differential switches trip. Check the
connection.
An indicator light comes on when the hob
is plugged in. This is normal. The message
disappears after 30 seconds.
A smell is produced when the hob is used for
cooking the fi rst few times. Heat up a pan of
water on each ring for ½ an hour.
The hob does not switch on and a message
appears. Call the technical service.
The hob does not switch on and
on the display. Remove the child lock (4.1.1).
The hob does not switch on
appears on the display and a beep sounds.
Clean the hob or remove any objects on the
sensors (4.1.2).
e n g l i s h
Maintenance and
cleaning
Troubleshooting
or
appears
15