GYS FLASH 6.24 PL Mode D'emploi page 8

GYSFLASH 6.24 PL EN
• Wear protective goggles and gloves.
• In case of contact with the eyes or the skin, rinse immediately
with water and see a medical doctor as soon as possible.
Do not leave a charging battery unattended for a long time.
Connection / disconnection :
• Ensure that the charger is not connected to the mains before
connecting or disconnecting clamps to the battery terminals.
• Always ensure the red clamp is connected to the «+» battery
terminal first. If it is necessary to connect the black clamp to
the vehicle chassis, make sure it is a safe distance from the
battery and the fuel line. The charger must then be plugged
into the mains.
• After charging, disconnect the charger from the mains, then
disconnect the negative clamp from the body of the car and
then disconnect the positive clamp from the battery, in this
order.
Connection :
• Class II device
• The connection to the power supply must be carried out in
compliance with national standards.
Maintenance:
• If the power cable is damaged, it must be replaced by the
manufacturer, its after sales or by an equally qualified person
to prevent any accidents.
• Maintenance should only be carried out by a qualified
person.
• Warning ! Always disconnect from the mains before
performing maintenance on the device.
• The device does not require any specific maintenance.
• If the internal fuse is melted, it must be replaced by the
manufacturer (GYS dedicated after sales service) or by an
equally qualified person to prevent any accidents.
• Do not use solvents or any agressive cleaning products.
• Clean the device surfaces with a dry cloth.
Regulations :
• The Machine is compliant with European directives.
• The declaration of conformity is available on our website.
• EAEC Conformity marking (Eurasian Economic Community).
• Equipment in compliance with British requirements. The
British Declaration of Conformity is available on our website
(see home page).
8