Publicité
Les langues disponibles
Les langues disponibles
Helios Ventilatoren
flexpipe
plus
Pos.
Assembly
3
Assembly of single spigot*
Please pay attention to the symbols on the
single spigots and multi-distribution box
prior to installation!
1. When inserting the single spigot, the open lock
symbol "OPEN" must be aligned with the mar-
king arrow in the sheet metal (Fig.1).
2. Insert single spigot into the sheet metal cut-
out, press down against the resistance of the
seal until it reaches the stop (Fig.1).
3. Turn single spigot in the clockwise direction
until it reaches the stop "CLOSED" ("Click")
(Fig.2).
Assembly of spigot cap with seal
1. Pull seal ring onto spigot cap (Fig.3).
Apply lubricant to the seal ring!
2. Insert spigot cap into single spigot until it
reaches the stop and push in unlockable clips
("Click") (Fig.4).
Assembly of flexible ventilation duct
with seal
1. Pull the seal ring on the second wave trough of
the ventilation ducting and apply lubricant
(Fig.5).
2. Insert ventilation duct FRS-R.. into the single
spigot until it reaches the stop (Fig.6).
3. Push in unlockable clips on both sides until
they reach the stops in the clip receivers
("Click") (Fig.6).
Unlockable clips can be pushed into the
clip receivers from both sides!
Multi-distribution box FRS-MVK.. for supply and extract air distribution
Fig.1
"OPEN"
Marking arrow
in sheet metal
Fig.3
Fig.5
* Illustration of assembly with circular ducting as example. Assembly for oval duct is identical.
4
Fig.2
À
Á
Fig.4
Fig.6
Seal ring
in second wave
trough
EN
"CLOSED"
"CLICK"
Direction of rotation
"CLICK"
Unlockable clips
"CLICK"
Publicité
