Cardin ZVL548.00 Mode D'emploi page 21

Note:
(1)
you cannot memorize a transmitter that has already been memorised: in this case the symbol '=' will
appear on the LCD display.
(2) when the memory is completely full, the buzzer will sound 5 "beeps" one after the other and the indica-
tion "E03- memory full" will appear on the display.
Cancelling a channel using a transmitter
• Scroll to menu "2) CANCEL TX", press
• Press the channel on the transmitter you wish to cancel, "Activation 2" will appear on the LCD display;
• Press the channel a second time (same TX, same channel), "SEARCHING....." will appear on the display
followed by one of the following:
- the symbol '-' means the channel has been cancelled.
- means that the channel is not present in memory.
NON TROVATO!
Cancelling one or more channels by means of memory position:
• Scroll to menu "3) CANCEL POS.", press
an arrow key
chosen position will appear on the LCD display (e.g. A B _ D).
• Using the keys move the cursor to the desired channel, press
letter. Repeat the procedure for all the channels you wish to cancel.
• Move the cursor to OK and press
with the asterisk symbol
Note:
(3) If the chosen location is free 'FREE!' will appear on the display
(4)
If you cancel all the activated channels the transmitter will have been eliminated from the system and
"ELIMINATED!" will appear on the display.
Cancelling the entire memory content:
• Scroll to menu "4) CANCEL MEM.", press
and hold down the
on the display for several seconds. At this point the entire memory content has been cancelled and the
receiver has been reset to factory settings.
Transmitter information
When the receiver detects the activation of a transmitter it proceeds to activate the relay that corresponds
to the channel that has been received. The following information appears on the LCD screen:
This information remains on the display for a maximum of four seconds.
2G/3G and WF cards
Dedicated cards that permit the receiver to hook up to a
card) and allows it to access a series of remote control functions. To connect to a
telephone SIM card for data traffic is required. The details for the installation and management of the
WF
and connections are explained in detail in the software instruction manual which can be downloaded
from the Software Download Centre on the website www.cardin.it.
to scroll to the location you wish to cancel, press
. "WAIT....." will appear on the display and the channels marked
ENT
*
will be cancelled
key for four seconds, the indication "CANCELLING" plus a progress bar will appear
"CH": the transmitter channel is already memorised - "P" : memory location
"SN": transmitter identification code - "A" : Channel received then activated
and "Activation 1" will appear on the LCD display;
ENT
and "Location 1" will appear on the LCD display, press
ENT
(4) .
and "CONFIRM?" will appear on the LCD display, press
ENT
2G/3G
mobile network ( local network for the WF
21
(3) , the channels present in the
ENT
*
and the symbol will replace the
ENT
2G/3G
mobile network a
2G/3G