Télécharger Imprimer la page

Cardin ZVL548.00 Mode D'emploi page 17

Radiocommande digitale avec afficheur lcd et fonction 3g/wf

Publicité

Les langues disponibles
  • FR

Les langues disponibles

• The use and installation of these appliances must rigorously respect the indications supplied by the manufac-
turer. The manufacturer accepts no liability for damage caused by, or situations arising from, the improper use of
these appliances.
Attention! Only for EU customers - WEEE marking.
This symbol indicates that once the products life-span has expired it must be disposed of separately from other rubbish. The
user is therefore obliged to either take the product to a suitable differential collection site for electronic and electrical goods
or to send it back to the manufacturer if the intention is to replace it with a new equivalent version of the same product.
Suitable differential collection, environmental friendly treatment and disposal contributes to avoiding negative effects on the ambient
and consequently health as well as favouring the recycling of materials. Illicitly disposing of this product by the owner is punishable
by law and will be dealt with according to the laws and standards of the individual member nation.
USE
This radio control device allows the remote activation of electrical and electronic appliances with its best use in the
following areas: automatic opening systems, alarm systems and multiple access systems (apartment blocks etc.)
The receiver has been designed for multiple access with up to 3000 users each of which may be memorised or
cancelled individually. The code is memorised in the receiver via radio. Each code is stored in a memory location
which can activate up to 4 functions. 1 transmitter = 4 functions max. = 1 location; 3000 users = 12000 functions max.
Transmitters 433 MHz
TXQ449100
TXQ449200
TXQ449300
TXQ449400
TXQ4492P0
TXQ4494P0
TXQ44940M
TXQPRO449-4
TXQPRO449-4A
Receivers 433 MHz
RCQ449-3G
RCQ449-3G10
RCQ449-WF
Memory module
This is extractable, furnished with a non-volatile EEPROM 24LC256 - 3000-code memory type (the receiver can
also be used with the 1000-code 24LC64 module present in the RCQ449D00 receiver) that contains the transmitter
codes. It is possible to move the memory module to another receiver, maintaining all the functions without having
to reprogram the other receiver.
The programmed codes are maintained in this module even in the absence of power without a time limit.
Attention! Removing and inserting the memory module must be carried out when the receivers are switched off
otherwise the memory content could become corrupt.
Receiver antenna: The installation of the antenna is fundamental, connected to the receiver it represents the
reception point for the radio control. A tuned antenna ANS400 (433 MHz) / ANQ800-1 (868 MHz) using a coaxial
cable RG58 (impedance 50Ω) with a maximum length of 15 m must be installed between binding posts 19-20. The
antenna should be positioned out of doors in the highest possible point, visible and away from metal structures.
3G/WF Antenna: The antenna for the 3G/WF card, which is a specific card supplied along with the product, must
always be installed. It should be screwed to the dedicated connector on the upper part of the box (see fig. 2).
Antenna extension:
In areas with a weak 3G/WF signal it is possible to install the antenna in a different location
using an accessory. The accessory consists of a cable in two different lengths and a holding bracket for installing
the antenna to the wall. The accessory is available in the following formats:
- antenna extension with a 5-metre cable ANSKITGSMWF5 / 5-metre cable ANSKITGSMWF10
IMPORTANT REMARKS
Transmitters 868 MHz
TXQ486100
TXQ486200
TXQ486300
TXQ486400
TXQ4862P0
TXQ4864P0
TXQ48640M
TXQPRO486-4
TXQPRO486-4A
Receivers 868 MHz
RCQ486-3G
RCQ486-3G10
RCQ486-WF
Description
1-channel transmitters
2-channel transmitters
3-channel transmitters
4-channel transmitters
2-channel precoded transmitters
4-channel precoded transmitters
4-channel wall-mounted transmitter
4-channel Industrial transmitters
4-channel Industrial transmitters + external aerial
Description
4-channel 3G receiver with LCD display (3000 codes)
4-channel 3G receiver with LCD display (3000 codes) + SIM
4-channel WF receiver with LCD display (3000 codes)
17

Publicité

loading

Ce manuel est également adapté pour:

Rcq-3g/wf