Resumption Of Service After Storage; Table And Torque Of Fastners - Baja motorsports DR90 Manuel De L'utilisateur

RESUMPTION OF SERVICE AFTER STORAGE

1. Remove the covering and remove the wooden blocks used in storing the vehicle. Change
the engine oil if the vehicle has been out of service for over 4 months.
2. Drain off the remaining atomized anti-rust oil from the fuel tank, followed by filling it with
fresh gasoline therein.
3. Prior to driving, all the required check-ups must be made. It is better to drive it at a low
speed in an open area to test its performance before normal operation.
TABLE AND TORQUE OF FASTENERS
Ser. No. Fastener
1 Front wheel axle nut
2 Rear wheel axle nut
3 Nut for tightening upper joining plate of front
fork with vertical tube
4 Nut for fixing engine
5 Rear arm nut
6 Exhaust silencer nut
7 Bolt for tightening upper joining plate of
fork with shock absorber
8 Bolt for fixing footrest
front

Torque (Newton/m)
(Foot/lb)
35-45Nm (26-33 ft.lb.)
50-60Nm (37-44 ft.lb.)
40-50Nm (30-37 ft.lb.)
20-25Nm (15- 18 ft.lb.)
35-50Nm (26-37 ft.lb.)
20-25Nm (15-18 ft.lb.)
15-20Nm (11-15 ft.lb.)
20-25Nm (15-18 ft.lb.)