Table des Matières
Publicité
CHECk-UPS, ADJUSTMENT AND MAINTENANCE
Checking the Oil
Check the engine oil each time prior to operating the dirt bike.
The oil level should be between the upper and lower lines of the oil gauge fitted in a screw
plug, which is on the right cover of the crankcase.
1. Set the motorcycle on level ground, screw off the oil gage plug, wipe the oil gage rod
clean and then insert the gage plug into the crankcase again to check the oil level. There
is no need to screw the oil gage plug into its hole in the crankcase.
2. Add lubricating oil up to the upper line when needed, but do not overfill.
3. Finally screw on the oil gage plug tightly.
CAUTION
Never start the engine when there is
insufficient lubricating oil. Otherwise, it will
cause harm to the engine.
Lubricating Oil Recommended
The lubricating oil is an important factor affecting the performance and service life of
the engine. Please refer to the chart for the correct grade of engine oil based on the
environmental conditions in your area. Do not use any other type of oil other than what is
recommended in the chart. DO NOT MIX OIL WITH THE GASOLINE.
Lubricating oils of different
viscosity shall be employed
in different regions and at
different temperatures.
MACHINE
OIL
°C
-30
TEMP.
°F
-22
Machine oil gauge
20W-50
5W-40 15W-50
10W-40 10W-50
10W-30
-20
-10
0
10
20
-4
14
32
50
68
30
40
86
104
Publicité
Table des Matières
