Eneo TER Serie Guide D'installation Rapide page 9

Initial setup
Formating the Hard Drive Disk
After adjusting the time and date for the first time, it is highly recommended to format
your Hard Disk Drive.
1. Go to the System Menu and select the HDD submenu.
2. Select the Check box next to the HDDs.
3. Click the [HDD Clear] button.
4. When the HDD formatting is complete, exit the main menu and reboot the DVR to
save all changes.
Main menu
The Main Menu (Setup Menu) system includes six (6) sub-menus: System, Device, Record,
Network, Backup, & Q. Setup. To access the Setup Menu, press the [Menu] button on the
front panel of the DVR, or right-click anywhere on the screen and select 'Setup Menu' .
The DVR's default user ID and password are: admin/ no password.
Initial setup
When all necessary cameras and monitors are setup in their permanent locations, con-
nect them to the DVR. Use the diagram in the Quick Start Guide and manual for addition-
al information. When all connections have been made, connect the DVR to an appropriate
power supply. The DVR will boot up automatically.
Date and time setup
1. Go to the System Menu and select SYS-
TEM INFO. Click on the pencil icon next to
the Date/ Time to enter edit mode.
2. Select the appropriate display format
from the [DATE/TIME FORMAT] drop down
lists.
3. Select the appropriate date and local
time in the [DATE/ TIME] section.
4. Select the appropriate time zone from
the [TIME ZONE] drop down list.
EN
9