Restart Delta Function; Manual Activation Of The Load System - Palazzetti WILMA Utilisation Et Fonctionnement

4.6 RESTART DELTA FUNCTION

temperature at which the stove switches on again automatically. For example, if the stove is set to switch off at
2 C (Eco Mode active) and "Restart delta" is set to 4 C, the stove will switch on again when the temperature
measured is less than or equal to 16 C.
To set the restart delta value:
a) Use the arrow buttons
b) Use the button to select the password "7" and then press
c) Select submenu
d) The value will ash; change it using the
e) Press the
Con guration 3 and 4:
To set the restart delta value:
a) Use the arrow buttons
b) Use the button to select the password "7" and then press
c) Select submenu
d) The value will ash; change it using the
e) Press the

4.7 MANUAL ACTIVATION OF THE LOAD SYSTEM

In case of rst use (pellet tank initially empty) or to test operation of the load unit, manual activation of loading
is possible.
On the control panel of the stove:
a) Using the arrow keys
b) Select password "7" with the key
c) Scroll with the key
d) Select password "54" with the key
e) Holding the key
f) Releasing the key will end the load operation.
Attention!
• This function is only active when the stove is off and cold.
• Before switching on again, ensure that there are no pellets in the grate.
26
to go to the setup menu
and press to con rm;
[8]
button to con rm the set value.
to go to the setup menu
[8] and press to con rm;
button to con rm the set value.
navigate to the set-up menu
and con rm with the key
and select sub-menu
the load system will activate and the display will show the incremental bars
is the number of degrees centigrade below the switch-off
and then press
and buttons ( 0,5 ... 5,0
and then press
and buttons (
0 ... 40
and press the key
[3 1 ]
;
and con rm with the key
;
to con rm;;
C);
;
to con rm;;
C);
;
;
;