Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Before operating the log splitter, the Bleed Screw should be loosened by some
rotations until air can go in and out of the oil tank smoothly.
Air flow thru the Bleed Screw hole should be detectable during the log splitter
is under operations.
Before moving the log splitter, make sure the Bleed Screw is tightened to avoid
oil leaking from this point.
FAILED TO LOOSEN THE BLEED SCREW WILL KEEP THE SEALED AIR IN
HYDRAULIC SYSTEM BEING COMPRESSED AFTER BEING DECOMPRESSED.
SUCH CONTINUOUS AIR COMPRESSION AND DECOMPRESSION WILL BLOW
OUT THE SEALS OF THE HYDRAULIC SYSTEM AND CAUSE PERMANT
DAMAGE TO THE LOG SPLITTER.
15. Max Pressure Limiting Screw
DO NOT ADJUST THE MAX PRESSURE
LIMITING SCREW !
Max pressure was set before the log
splitter ex work and the max pressure
limiting screw is sealed with glue to
ensure the log splitter works under
pressure no more than 5 tons. The
setting was done by qualified
mechanic with professional
instruments.
Unauthorized resetting will cause the
hydraulic pump fail to output enough
splitting pressure or RESULT IN
SERIOUS INJURY AS WELL AS DAMAGE TO
THE MACHINE .
WIRING DIAGRAM
PLUMBING DIAGRAM
15
35
Publicité
Table des Matières
