SAFETY WARNINGS & CAUTIONS
SAFETY WARNINGS & INSTRUCTIONS
UNDERSTAND YOUR LOG SPLITTER
Read and understand the owner's manual and labels
affixed to the log splitter. Learn its application and
limitations as well as the specific potential hazards peculiar
to it.
DRUGS, ALCOHOL AND MEDICATION
Do not operate the log splitter while under the influence of
drugs, alcohol, or any medication that could affect your
ability to use it properly.
AVOID DANGEROUS CONDITIONS
Put the log splitter on a 60 - 75cm high, stable, flat, and
level work bench where there is plenty of room for
handling, and help the operator stay altert. Bolt the log
splitter to the work surface if it tends to slip, walk, or slide.
Keep your work area clean and well lighted. Cluttered
areas invites injuries.
Do not use the log splitter in wet or damp areas or expose it
to rain.
Do not use it in areas where fumes from paint, solvents or
flammable liquids pose a potential hazard.
INSPECT YOUR LOG SPLITTER
Check your log splitter before turning it on. Keep guards in
place and in working order. Form a habit of checking to see
that keys and adjusting wrenches are removed from tool
area before turning it on. Replace damaged, missing or
failed parts before using it.
DRESS PROPERLY
Do not wear loose clothing, gloves, neckties or jewelry
(rings, wrist watches). They can be caught in moving parts.
Protective electrically non conductive gloves and non-skid
footwear are recommended when working. Wear protective
hair covering to contain long hair, preventing it from get
caught in machinery.
PROTECT YOUR EYES AND FACE
Any log splitter may throw foreign objects into the eyes.
This can cause permanent eye damage. Always wear
safety goggles. Everyday eyeglasses have only impact
resistant lenses. They are not safety glasses.
Do not put the log splitter on the ground for operations.
This is awkward operating position that the operator has to
bring his face close to the machine, and thus risks being
struck by wood chips or debris.
EXTENSION CORDS
Improper use of extension cords may cause inefficient
operation of the log splitter which can result in overheating.
Be sure the extension cord is no longer than 10m and its
section is no less than 2.5mm
2
to allow sufficient current
SYMBOL AFFIXED TO THE
MACHINE
30