emerio FG-117320 Mode D'emploi page 6

FG-117320
PARTS DESCRIPTION
1. Thermostat control switch
2. Air outlet grille
3. Indicator light
4. Feet
5. Clip for mounting
USAGE
The frost protector with thermostat is for keeping small rooms free from frost. It can only be used within the
home and for the purposes described. It is not for outdoor use.
DESCRIPTION
The frost protector is an electrical convector heater. It is fitted with a thermostat for maintaining the desired
temperature. A control lamp lights up when the frost protector starts to heat up. The thermostat controls the
room temperature and switches the heater on or off as necessary. The built-in temperature-monitor switches
the unit off if it is too hot and switches it on again after cooling down. The heater is always ready for use. To
switch off the frost protector, pull out the plug at the mains. (In its minimum (fully anti-clockwise) position, the
thermostat provides a frost guard position. In this position (depending on the size of the room) the heater will
maintain the temperature above freezing.
ASSEMBLY OF THE HEATER
When the heater is used on wall mounted, please read below instructions carefully:
1. Use an Electrical Drill (Size of Head drill Φ8mm) drilling 2 holes (a, b) on the wall, the distance between a
and b is 14.9CM, the depth is about 4cm.
2. Assemble the 2pcs Φ4X30mm screws and clip onto the wall, please pay attention to the minimum distance
above floor and below ceiling after mounting as Picture A & B shows.
3. Then find the correct position to fit the grooves at the back of the heater, let the clip hold the heater. After
that, use 2pcs of Φ3X10mm screws to firm the connection as Picture A shows.
- 5 -
EN