emerio FG-117320 Mode D'emploi page 5

19. Only connect the appliance to A.C. mains as specified on
the rating plate! Ensure that the plugs and cord allow high
power.
20. The frost protector should not be installed in areas with
fire hazards, such as garages, stables, or wooden shed.
This also applies to rooms in which highly inflammable
gases or dust can develop. Danger of fire!
21. The room to be heated should not contain any easily
inflammable materials (e.g. petrol, solvent, spray canisters
etc.) or other easily combustible materials (e.g. wood or
paper). Keep such materials away from the equipment.
Danger of fire!
22. The surface of the heater becomes hot. Do not install
directly below an electrical socket.
23. Do not use the frost protector when the unit or power
cable is defective. Repairs are only to be carried out by a
specialist.
24. Never operate the appliance with wet hands! Danger to
life!
25. The unit is ready for use even when at the lowest setting
level. In order to switch off the frost protector, pull out the
power supply plug or turn off the permanently installed
disconnecting switch (e.g. automatic cut-out, installation
switch etc.)
26. This heater is mainly used as frost guard.
27. The appliance should not be operated by means of an
external timer-switch or by means of a separate system
with remote control not originally belonging to this
appliance.
28. This heating device is not suitable for assembling in
vehicles and machines.
29. Regarding the information pertaining to the installation,
please refer to the below paragraph of the manual.
These instructions for use belong to the appliance and must
be kept in a safe place. When changing owners, these
instructions must be handed over to the new owner!
- 4 -