Operation Instructions - Kärcher K2300PS Manuel D'utilisation

wand and hand tightening the
threading of the gun onto the wand.
4. Pull the lever on the trigger gun to
make sure that water is flowing freely
and that all air has been purged from
the device.
NOTE: We recommend that you test
the GFCI as part of your startup
procedure each time you use the
device, see chapter GFCI
INSTRUCTIONS.
Do not use if GFCI fails test.
GFCI Instructions
1. Plug the Ground Fault Circuit
Interrupter (GFCI) into a working
outlet.
2. Press "TEST", then press "RESET" to
assure proper connection.
10 English
1 2
NOTE: The actual appearance of the
GFCI may be different from this illustra-
tion.

Operation Instructions

ATTENTION
Pump running dry will cause
damage to the device.
If pressure does not build up in the
device after 2 minutes then switch the
device off and proceed according to
the instruction in chapter,
Troubleshooting guide.
High Pressure Operation
NOTE: Maintain a spraying distance
of at least 12 inches (30 cm) when
cleaning painted surface. Do not get
closer than 24 inches (60 cm) (0r 2
feet) when washing a vehicle.
1. Install the nozzle with the quick
connect on the end of the wand by
pulling the collar back, inserting the
soap nozzle, then pushing the collar