Table des Matières
Publicité
Modèle 3030P
Ludlum Measurements, Inc.
20 = Set alpha source count time (secs), format #####.#
21 = Set beta source count time (secs), format #####.#
22 = Set background count time (secs), format #####.#
23 = Set QC override status, 0 = OFF, 1 = ON
SR – Reset All Samples
This command clears all logged samples from memory.
SThhmm – Set Time
This command sets the real-time clock. Seconds are always started at 00.
SUxxxxxxxxxx – Set Command
This command sets a user-defined, 10-character comment, which is saved
with the logged samples.
SVxxxx – Set High Voltage
This command sets high voltage from 0000 to 2000 volts.
SXnyyy – Set Crosstalk
This command sets the beta-to-alpha or alpha-to-beta crosstalk. The
crosstalk must be multiplied by 10 before sending.
1 = Set beta-to-alpha crosstalk.
2 = Set alpha-to- beta crosstalk.
SYn – Set Recycle Mode
This command sets recycle mode. If recycle mode it ON, after a count
completes, another one will be started automatically.
0 = Set recycle mode OFF.
2 = Set recycle mode ON.
Snxxxxxx – Set Alarm
This command sets the specified alarm set point.
1 = Set alpha alarm set point.
2 = Set beta alarm set point.
3 = Set alpha + beta alarm set point.
Manuel Technique
Page 38
Section 7
May 2013
Publicité
Table des Matières
