Assembly - Power Stroke PSL1PS11 Manuel D'utilisation

RAPID VALVE RELEASE
Dried paint or other debris can clog the check valve and
prevent the unit from priming correctly. Pressing the Rapid
Valve Release button before each start keeps paint flowing
cleanly through the check valve and allows quick and easy
start-up of the unit.
UNPACKING
This product requires assembly.
 Carefully lift the product from the carton and place on a
level work surface.
WARNING:
Do not use this product if any parts on the Loose Parts
List are already assembled to your product when you
unpack it. Parts on this list are not assembled to the
product by the manufacturer and require customer instal-
lation. Use of a product that may have been improperly
assembled could result in serious personal injury.
 Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
 Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the paint
sprayer.
 If any parts are damaged or missing, please call
1-877-617-3501 for assistance.
LOOSE PARTS LIST
See Figure 1, page 16.
Description
Pistol-Grip Sprayer With with Nozzle Tip Guard ............... 1
515 Reversible Spray Tip .................................................. 1
311 Reversible Spray Tip .................................................. 1
25 Ft. High Pressure Hose ................................................ 1
Garden Hose Adaptor ....................................................... 1
Wrenches........................................................................... 2
Operator's Manual (Not Shown) ........................................ 1
FEATURES
VARIABLE PRESSURE CONTROL
 Lower pressure is for priming, cleaning, rolling, and
for thinner materials.
 Higher pressure is ideal for latex and airless spraying
applications.

ASSEMBLY

WARNING:
If any parts are damaged or missing do not operate this
paint sprayer until the parts are replaced. Use of this
product with damaged or missing parts could result in
serious personal injury.
WARNING:
Do not attempt to modify this paint sprayer or create
accessories not recommended for use with this paint
sprayer. Any such alteration or modification is misuse and
could result in a hazardous condition leading to possible
serious personal injury.
WARNING:
Do not connect to power supply until assembly is com-
plete. Failure to comply could result in accidental starting
and possible serious personal injury.
INSTALLING SPRAY TIP AND NOZZLE TIP
GUARD
Qty. See Figure 2, page 17.
See paint sprayer operator's instructions for spraying, prim-
ing, and cleaning before installing nozzle tip guard and spray
tip. Note all warnings regarding use of pistol-grip sprayer
and the possibility of injection.
 Turn off the paint sprayer and relieve pump pressure.
 Turn lock-off lever counterclockwise to lock sprayer trig-
ger.
 Select spray tip and push securely into nozzle tip guard.
 Install tip saddle and tip seal into nozzle tip guard.
 Thread nozzle tip guard assembly onto pistol-grip sprayer
and tighten securely.
 Keep pistol-grip sprayer trigger locked when not in use.
Page 8 — English