Power Stroke PSL1PS11 Manuel D'utilisation page 12

NOTICE:
It is important to thoroughly clean paint sprayer and
pistol-grip sprayer after each use or when changing paint
color. Allowing paint or stain to remain in an idle paint
sprayer for an extended period of time may cause its
hoses to clog and its moving parts to seize.
 Always use drop cloths or other cover to protect areas
from possible spills.
 Lock pistol-grip sprayer and follow Release Pressure
Procedure.
 Unplug the paint sprayer.
 Remove the spray tip, nozzle tip guard, tip saddle and
tip seal from sprayer.
 Soak spray tip(s) and nozzle tip guard in water (for
water-based paints) or Klean Strip
Formula Paint Thinner or Klean Strip
Thinner (for oil-based paints or varnish); rinse.
 Fill a bucket (waste container) with water (for water-based
paints) or Klean Strip Revolutionary White Formula Paint
®
Thinner or Klean Strip
oil-based paints or varnish).
NOTE: If flushing or cleaning using water for water-based
materials, it may be easier to use a garden hose and the
garden hose attachment (included). Remove filter from
intake tube and attach intake tube to garden hose with
attachment.
 Place intake tube into the bucket of water (for latex
materials) or Klean Strip
Paint Thinner or Klean Strip
(for oil-based materials).
 Place return tube into waste container.
 Turn prime/spray lever to PRIME.
 Turn variable pressure control to PRIME.
 Plug in the paint sprayer.
 Turn on/off switch to ON. The paint sprayer will draw
cleaning fluid up the intake tube through the pump and
out the return tube into the waste container. Allow the
cleaning fluid to run through the system until it runs clear.
OPERATION
Revolutionary White
®
Safer Green Paint
®
Safer Green Paint Thinner (for
®
Revolutionary White Formula
®
Safer Green Paint Thinner
®
Page 12 — English
 Turn prime/spray lever to SPRAY.
 Unlock pistol-grip sprayer.
 Point sprayer at the interior side of waste container to
flush out the high-pressure fluid hose and pistol-grip
sprayer.
 Leave system running for approximately one minute or
until cleaning fluid runs clear.
 Turn prime/spray lever to PRIME.
CLEANING THE PAINT SPRAYER WITH
GARDEN HOSE (FOR LATEX MATERIAL ONLY)
See Figure 14, page 19.
 Remove filter from intake tube.
 Attach garden hose adaptor to garden hose.
 Push garden hose adaptor onto the intake tube and
secure with butterfly clamp.
 Turn prime/spray lever to PRIME.
 Turn variable pressure control to PRIME.
 Turn on garden hose.
 Turn on/off to ON.
 Run water through system until clear water runs out of
the return tube.
 Turn prime/spray lever to SPRAY.
 Unlock pistol-grip sprayer.
 With the nozzle tip guard assembly removed, point the
pistol-grip sprayer at the interior side of waste container
to flush out the high-pressure fluid hose and pistol-grip
sprayer.
 Leave the system running until clear water runs out of
the pistol-grip sprayer.
 Turn prime/spray lever to PRIME.
 Turn on/off switch to OFF.
 Unplug the paint sprayer.
 Dispose of dirty water in accordance with federal, state,
and local ordinances.