GRAUPNER TERRY S Mode D'emploi page 20

Keep the adhesive in a safe place, well out of the reach of children.
On no account use Styrofoam cyano-acrylate ("foam cyano"), white glue (PVA
wood glue) or epoxy resin adhesives. These glues do not produce strong joints
between any of the kit materials and the SOLIDPOR high-density foam.
Fuselage and tail
Locate the channel for the spruce fuselage reinforcement (2) and use a balsa knife to
continue it full-length. Tip: simply slit the material with the balsa knife, then push out
the unwanted SOLIDPOR material using the spruce strip (2).
Trial-fit the spruce strip, and ensure that it makes good contact with the underside of
the fuselage over its full length. This is important, as it will be impossible to insert the
fin (4) completely if the strip is fitted incorrectly.
The production process leaves an unwanted piece of foam at the nose of the
fuselage; remove this to provide space for the power cables attached to the SPEED
400 PLUS.
GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
Änderungen vorbehalten! Keine Haftung für Druckfehler! Id.-Nr. 0058674 03/2008
20