GRAUPNER TERRY S Mode D'emploi page 24

Glue the nylon inserts (13) in place: fit the nylon screws (14) in the inserts first, so
that you can press them fully into their recesses.
Slide the SPEED PLUS motor unit into the fuselage from the front, pushing it back as
far as it will go. Fit the folding propeller on the motor shaft to check the position, then
secure the motor with a little glue applied to the front edge. The propeller should not
be fixed permanently until you have test-run the motor.
GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
Änderungen vorbehalten! Keine Haftung für Druckfehler! Id.-Nr. 0058674 03/2008
24