Publicité
Les langues disponibles
Les langues disponibles
The fin can now be glued in place permanently. Caution: do not use activator for
this joint.
Apply cyano to the spruce strip (2) and the inside of the fuselage sides, then slide the
fin briskly into place. Check that it makes contact with the rear end-stop.
Cut a slot about 1 mm wide at each end of the elevator so that it is free to deflect.
Move the elevator up and down repeatedly until the hinge is reasonably free-moving.
Glue the aluminium sleeve (11) and the elevator horn (9) in place. Caution: do not
use activator when gluing the sleeve. The tailplane can now be attached to the
fuselage using the retaining screw (12); you will need to deflect the rudder to one
side to reach the screw.
GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
Änderungen vorbehalten! Keine Haftung für Druckfehler!
Id.-Nr. 0058674
03/2008
23
Publicité
