Briteq BT-Dazzle Mode D'emploi page 6

ENGLISH
2. FUNCTION LEDS
3. BUTTONS
4. DMX IN/OUTPUTS: used for DMX512 linking, you can use good quality balanced signal cables with 3pin
XLR-connectors.
5. REMOTE CONTROL INPUT: Used to connect a simple CA-8 hand controller while the unit is used in
standalone or master/slave mode.
6. MICROPHONE: is used to control the sound triggered programs
7. MAINS INPUT / OUTPUT: with PowerCON
daisy chain several units, up to max 16A. Input and output are connected to each other without any fuse.
Hint: Please check our website for special cable assemblies that contain both power (3x1.5mm² with Neutrik
®
PowerCON ) and balanced signal (XLR 3pin) in one cable. Different lengths are available: 1.3m, 3m, 5m and
10m, very convenient!
8. MAINS FUSE: this fuse only protects the electronics of the projector, mains input/output (7) is not fused.
MAIN MENU:
 To select any of the functions, press the [MENU]
button up to when the required one is shown on
the display or use the [DOWN] and [UP] buttons to
browse the menu.
 Select the function with the [ENTER] button (the
display blinks).
 Use [DOWN] and [UP] buttons to change the
mode.
 Once the required mode is selected, press the
[ENTER] button to select.
 Press the [MENU] button for about 2 seconds to
store the setting and to return to running mode.
If you don't do this, the setting will not be stored
and after about 8 seconds, the fixture will return to
the previous running mode.
DMX Address
Used to set the starting address in a DMX setup.
 Press the [MENU] button until [DMX Address] is
shown on the display.
 Press the [ENTER] button, the display starts
blinking.
 Use [DOWN] and [UP] buttons to change the
DMX512 address.
 Once the correct address is shown on the display,
press the [ENTER] button to select it.
 Press the [MENU] button for about 2 seconds to
store the setting and to return to running mode.
Channel mode
Used to set the desired channel setup mode.
 Press the [MENU]] button until [Channel mode] is
shown on the display.
 Press the [ENTER] button, the display starts
blinking.
BRITEQ
®
DMX On
MASTER On
SLAVE On
SOUND Flashing
MENU To select the programming functions
DOWN To go backward in the selected functions
UP To go forward in the selected functions
ENTER To confirm the selected functions
DMX input present
Master mode
Slave mode
Sound activation
®
sockets, connect the supplied mains cable here, you can
4/80
OPERATION MANUAL
BT-DAZZLE