Procedures In The Event Of Faults; Repairs - Calira EVS 17/16-DS/IU Mode D'emploi

Procedures in the event of faults

The device is maintenance-free. However, if any faults do
occur, please proceed according to the following table:
Fault Action
The device is not – Check the circuit breaker and
working.
The battery is not being – Check all connections from
charged.
12 V circuits are not – Check the fuses and replace
being supplied.
– Check the connections to the
The voltage of the – Start the motor and let it run
Battery 2 has dropped to
below 1.5 V; the mains
charging process does
not start.
None of the faults Please contact the manufacturer.
described here seems to
apply. But the device still
does not work.
34
the mains connection.
the charger to the battery. Pay
attention to the correct polarity.
Unplug the mains plug of the
device and reinsert it.
them if necessary.
affected circuits.
for approx. 30 seconds. Battery
voltage rises above 1.5 V.
The charging process starts
automatically.

Repairs

Do not undertake any repairs or modifications to the
device!
A faulty device can only be repaired by the manufacturer or by
its service personnel. Please note the relevant general safety
regulations.
Service
CALIRA Electronic GmbH & Co. KG
Lerchenfeldstraße 9
87600 Kaufbeuren
www.calira.de
service@calira.de
Telephone +49 (0)83 41 97 64 30
Telefax +49 (0)83 41 97 64 70