Publicité
Les langues disponibles
Les langues disponibles
Cleaning the metal parts
To clean the metal parts of the stove, use a soft cloth
dampened with water. Never clean the metal parts with
alcohol, thinners, petrol, acetone or other degreasing
substances. If such substances are used, our company
declines any responsibility.
Eventual variations in the colour of the metal parts can be
caused by an incorrect use of the stove.
It is necessary to daily clean
the brazier and often clean the
ash box. The lack of cleanliness
can prevent the starting of the stove,
causing damages to the stove itself and
to the environment (possible emission of
unbrunt material and soot). Do not re-
use the pellet possibly remained in the
brazier due to no starting-up.
Cleaning the brazier and brazier support
When the flame assumes a red colour or seems weak, and
is accompanied by black smoke, this means that there are
ash deposits or incrustations that do not permit the correct
functioning of the stove and that must be removed
(Pict. 5). Remove the brazier every day by simply raising
it from its slot; then clean out the ashes and eventual
incrustations that may have formed, paying particular
attention to liberating the holes by using a pointed tool
(not included with the stove). This operation is made
particularly necessary before every lighting the first several
times and above all if using pellets that differ from those
supplied by our company. The frequency of this operation
is determined by how frequently the stove is used and the
choice of pellets. It is also a good idea to check the brazier
support, vacuuming the eventual ash present.
56
Daily cleaning by scraper (where present)
With stove off and cold, activate 5-6 times the duct scraper
of the heat exchange by raising and lowering the knob
placed in the compartment under the door of the top.
Cleaning of the flame-shell
Remove the flame beater from its seat and proceed with
cleaning according to the following procedure:
• Pull a few centimetres towards you the flame beater until
it is released completely (1).
• Turn the flame beater by about 30° and extract it from
the combustion chamber (2).
• Remove with an aspirator all the ash deposited on top
of the flame beater.
• Replace the flame beater in its original position and
make sure that it is securely inserted.
2
Cleaning ash box
Open the door and extract
the ash box. Use a vacuum
to
remove
all
the
deposited within.
This operation must be
performed more or less
frequently depending on the
quality of the pellets used.
1
ash
Publicité
