Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Set Netmask
To set the Netmask, follow the instructions below:
1.
Use the knob to select 3.Set Netmask.
2.
Press the knob.
3.
Use the knob to select one of the following options:
•
A. 255.000.000.000
•
B. 255.255.000.000
•
C. 255.255.255.000
•
Exit (to cancel)
Operating Mode
The Net-X II can operate as a splitter/converter, or a DMX merger. To switch between the 2 modes, do the
following:
1.
Use the knob to select either 1. 8 Port (Assigns each port as an output/input (this also supports
RDM over Ethernet) or 2. 2 + 8 Port (Supports DMX merging with the two DMX inputs).
2.
Press the knob.
3.
3.Exit (to cancel)
DMX Port Settings
The Net-X II has 8 DMX ports that can be set as outputs or inputs. To select a DMX port to configure, follow
the instructions below:
1.
Use the knob to select 5.DMX Port Settings.
2.
Press the knob.
3.
Use the knob to select the desired DMX port, from DMX Port 1-8, or Exit (to cancel).
4.
Press the knob.
Port Mode
The port mode determines whether the selected port functions as an input, an output, or is disabled.
1.
Select the DMX port to configure as instructed in
2.
Use the knob to select 1.Port Mode.
3.
Press the knob.
4.
Use the knob to select the desired port mode from, 1.DISABLE, 2.OUTPUT, or 3.INPUT, or Exit
(to cancel).
5.
Press the knob.
•
For 2.OUTPUT, select the protocol from 1.ArtNet, 2.sACN, or 3.DMX Input, or 4.Exit (to
cancel). Press the knob then use the knob to select the source universe (for 1.ArtNet: from
000–255; for 2.sACN: from 001–256) or the source DMX port (for 3.DMX Input: from 001–
008). Then, press the knob.
DMX Merge
The Net-X II is capable of merging two signals of the same protocol into one, using HTP
(Highest Takes Precedence), or LTP (Latest Takes Precedence) logic.
1.
Select the DMX port to configure as instructed in
2.
Use the knob to select 2.DMX Merge.
3.
Press the knob.
4.
Use the knob to select the desired mode, from OFF (to disable mode), HTP (Highest Takes
Precedence), or LTP (Latest Takes Precedence).
5.
Press the knob.
13
DMX Port
Settings.
DMX Port
Settings.
Net-X II User Manual Rev. 2
Operation
Publicité
Table des Matières
