Publicité
Les langues disponibles
Les langues disponibles
can become wedged and lead to loss of control over the tool.
o) When the cut is completed, switch off the tool and then pull the blade out of the cut only after
it has come to a complete standstill. To avoid any kickback. Then you can put down the tool
securely.
p) Do not brake the blade to a stop by applying pressure on its sides after switching off. The
blade can get damaged, break or cause kickback.
q) Always wait until the machine has come to a complete stop before placing it down. The
accessory can jam and lead to loss of control over the power tool.
(C) Special warnings when using the product
1. Become familiar with the controls and the proper use of the tool.
2. Keep children and bystanders away
Do not let bystanders touch the tool or its power cable or the extension cord.
All bystanders (esp. children) should be kept away from tool and work area.
Keep the product away from children or from their environment. Never allow children to operate the
tool. Children should be supervised to ensure that they do not play with the tool.
3. The use of this product is forbidden to children.
4. Only well-instructed adults should operate the product. This product is not intended for use by
persons (including children) with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision or instruction concerning use of
the product by a person responsible for their safety.
5.1. Do not use the tool in wet or damp conditions, areas. Keep work area free from tipping
hazards.
5.2. Do not work with materials containing asbestos.
6. Never put down the tool unless the tool is switched off and the shaft and blade have come to a
complete stop. Always stop the tool before putting it down (note: Ensure that blade is no longer
moving when you put down the tool).
7. Keep hands and other body parts well away from the workpiece while tool is in use.
Keep hands well away from the underside of the workpiece during use. Do not use your hands to
remove any dust, chips or other waste while the tool is in use. Do not touch the blade right after
operation, as it may be hot and cause burns. Never seize the shaft or blade during operation.
8. Residual risks
Even when the tool is used as prescribed it is not possible to eliminate all residual risk factors. The
following hazards may arise in connection with the tool's construction and design:
a. Damage to lungs if an effective dust mask is not worn.
b. Damage to hearing if effective hearing protection is not worn.
c. Health defects resulting from vibration emission if the power tool is being used over longer period of
time or not adequately managed and properly maintained.
d. Health hazard resulting from dusts from materials containing harmful substances. Wear respiratory
protective equipment.
8.1. Noise level
Wear ear protection. Wear hearing protection while operating the power tool.
The measured values have been measured in accordance with a standard test method.
The measured values are mentioned in the characteristics table.
WARNING:
A certain level of noise emitted from this machine is not avoidable.
Plan noisy work according to local laws and at specific times.
Keep rest periods and if necessary restrict the working hours to a minimum.
For your own personal protection and the protection of bystanders have suitable hearing protection
worn.
Page 16 of 33
Publicité
