livin flame Duvin Instructions De Montage Et D'utilisation page 26

 Hold
for 3s or wait for 10s to save and exit the heating time period
setting.
3.2.26 Press , '←' and '→' to check your week timer settings.
3.2.27 If heating needs to be turned off, it will be necessary to go back to the Normal
Control Mode to turn off.
Advance Mode
3.2.28 Under the daily and week timer mode, Press
3.2.29 To turn the heater off when the heater is on during a preset heating period.
3.2.30 To turn the heater on when the heater is off in between preset heating
periods.
Adaptive Start Control
3.2.31 According to room temperature and settemperature, the heater will
automatically come on in time to heat the room to the set temperature at the
set time. For example, if your timer is set to start at 18:00 and temperature is
set to 23°C, the fire will come on at 17:30 to ensure the room is 23°C at 18:00.
Window Open Detection
3.2.32 When the transmitter detects a rapid drop in room temperature, it will be
judged as a window open, the warning icon will be displayed and the heating
will be turned off automatically.
3.2.33 After the indoor temperature has risen or a manual override of the warning
(by operating remote control) has been done, the fire will return to normal
working state.
Set up the communication between the remote and appliance
3.2.34 The below operations should be carried out before programming, when
changing to a new remote or in the event the appliance cannot be controlled
by the remote:
 Hold the reset button on the appliance for 3 seconds (pen point may needed)
until you hear 3 short beeps from the unit, release the button.
 Press the button on the remote, the programming is finished when you
hear 1long beep from the appliance.
3.2.35 Resetting the code for remote control is necessary if the appliance operates
wrongly or the remote control does not operate correctly.
 Open the back cover of the remote control.
 Press the Reset button on remote handset.
 Follow the steps 6b.34
:
26