Publicité
Les langues disponibles
Les langues disponibles
● Operating by Remote Handset
In order to protect the product from becoming too hot, there is an 8s delay when turning on the
heater; also there is an 8s delay when turning off the heater fan.
Make sure the battery are installed properly in the remote control.、
The effective range of the remote control is up to 4 meters or 13 feet
HEATER BUTTON
Press once turns Fan on, and 8s later Low heat on. (Pilot lights illuminated ●○)
Press again turns on High heat. (Pilot lights illuminated ●●)
Press third time turns heat off. 8s later fan off (Pilot lights illuminated ○○)
There are 3 levels you can cycle through including the OFF setting.
3.2 Operating by Remote Handset
Make sure the battery are installed properly in the remote control.、
The effective range of the remote control is up to 4 meters or 13 feet.
NOTE: This is thermostatic remote control. The remote should be in the same room as fireplace and placed
on a flat surface. It must be placed away from the fire so the hot air will not
blow on it and affect thermostatic reading.
The communication frequency between the fire and remote has already been set
up. If you cannot use the remote with the fire, please follow instructions Step
3.2.34 to initiate this connection in point.
Standby for Remote Handset
3.2.1 The screen shown to the right is when the remote handset is in
standby condition.
Turn on/off
3.2.2 Press
to turn on the flame effect, turn off flame effect and heater
when in normal mode.
3.2.3 Press
to turn on/off the flame effect under daily and weekly timer
mode.
23
Publicité
