SECTION 3: OPERATING INSTRUCTIONS
This appliance can be operated by both remote control and manual button. Once the unit has been
properly connected to an earthed electrical outlet, turn on the main switch located on the right hand
side of the appliance. A beep should be heard when the power is first applied.
NOTE! To use both remote and manual functions the manual on/off switch must be in 'ON'
position. In order to protect the product not becoming too hot, there is 8s delay when turning on the
heater; also there is 8s delay when turning off the heater fan.
3.1 Operating by Manual Button
NOTE! The manual button on the fire box unit will not provide you with all function control, and its
propose is to control some basic function when you lose the remote handset. Please use the remote
hand set to carry out all functions.
NOTE:The flame will always on when the appliance is on.
Main power switch
The POWER switch supplies power to all of the functions of the fireplace. This switch must be in the
"ON" position for any of the functions including the remote to work.
Power button
By pressing the POWER button, turn the fireplace on when it is off or turn it off when it is on.
Flame button
By pressing the FLAME button, the unit will cycle through four flame effects.
Fuel bed button
By pressing the FUEL BED button to cycle through 13 fuel bed effects.
To Reset the Heater
Your heater includes a protection system that shuts off the heater if it overheats for any reason:
1) Turn unit to off.
2) Unplug unit wait 5 minutes.
3) Plug in and turn on.
22