Table des Matières
Publicité
Certificate No:
Date of Issue:
Manufacturer:
Additional Manufacturing
location(s):
MTS Systems Corporation, Sensors Division
3001 Sheldon Drive
Cary
NC 27513
United States of America
This certificate is issued as verification that a sample(s), representative of production, was assessed and tested and found to comply with the
IEC Standard list below and that the manufacturer's quality system, relating to the Ex products covered by this certificate, was assessed and
found to comply with the IECEx Quality system requirements. This certificate is granted subject to the conditions as set out in IECEx
Scheme Rules, IECEx 02 and Operational Documents as amended.
STANDARDS:
The electrical apparatus and any acceptable variations to it specified in the schedule of this certificate and the identified documents, was
found to comply with the following standards:
IEC 60079-0 : 2011
Edition:6.0
IEC 60079-1 : 2014-06
Edition:7.0
IEC 60079-26 : 2014-10
Edition:3.0
IEC 60079-31 : 2013
Edition:2
IEC 60079-7 : 2015
Edition:5.0
This Certificate does not indicate compliance with electrical safety and performance requirements other than those expressly included in the
TEST & ASSESSMENT REPORTS:
A sample(s) of the equipment listed has successfully met the examination and test requirements as recorded in
Test Report:
GB/CML/ExTR16.0064/00
Quality Assessment Report:
GB/FME/QAR14.0005/00
IECEx CML 16.0039X
2016-06-09
MTS Sensor Technologie GmbH & Co KG
Auf dem Schüffel 9
58513 Lüdenscheid
Germany
Explosive atmospheres - Part 0: General requirements
Explosive atmospheres - Part 1: Equipment protection by flameproof enclosures "d"
Explosive atmospheres – Part 26: Equipment with Equipment Protection Level (EPL) Ga
Explosive atmospheres - Part 31: Equipment dust ignition protection by enclosure "t"
Explosive atmospheres – Part 7: Equipment protection by increased safety ''e''
Standards listed above.
GB/CML/QAR16.0004/00
IECEx Certificate
of Conformity
Issue No: 0
Page 2 of 3
Publicité
Table des Matières
