Luminance Brands Kathy Ireland Home ARLO INDOOR Manuel Du Propriétaire page 7

3. Ceiling Fan Assembly
3.5
Remove the Hanger Ball by loosening the Phillips Head
Set Screw in the Hanger Ball until the Ball falls freely
down the 4 .5" Downrod (Figure 5) .
Remove the Pin from the 4 .5" Downrod, then remove the
Hanger Ball (Figure 5) .
Retain the Pin and Hanger Ball for reinstallation in
Step 3 .12 .
NOTE: Do not loosen the screw that attaches the
green ground wire to the hanger ball.
3.6
Separate, untwist and unkink the Five 80" Motor Wires .
Route the Five 80" Motor Wires through the 4 .5"
Downrod (Figure 6) .
3.7
Loosen the two Phillips Head Set Screws in the Motor
Coupler for installation of the Downrod (Figure 7) .
Seat the Downrod in the Motor Coupler (Figure 7) .
Rotate and align the Downrod Holes with the two Holes
in the Motor Coupler (Figure 7) .
(Continued)
PIN
PHILLIPS HEAD SET SCREW
Figure 5
(LOOSENED)
Figure 6
DOWNROD
MOTOR
COUPLER
Figure 7
7
GREEN GROUND WIRE
4.5" DOWNROD
HANGER BALL
80" FAN MOTOR
WIRES (5)
4.5" DOWNROD
LOOSEN SET
SCREWS (2)
luminancebrands.com
Please contact 1-800-777-4440 for further assistance
ETL Model No.: CF345 & CF355