Table des Matières
Publicité
VERS. 04.12.2019
4 PANNES –CAUSES ET REPARATION
4.1 Comportement en cas de panne
En cas de panne pendant l'utilisation de la machine, éteignez-la et isolez-la de l'alimentation électrique. Les
travaux concernant le système électrique ou l'alimentation de la machine ne peuvent être effectués que par
un électricien qualifié.
4.2 Trouble-shooting guide
Trouble
1.Product does not
start
2.Product does not
reach full power
3. Product does not
cut
4.Unsatisfactory
result
5. Excessive
vibration or noise
Possible source
1.1. Not connected to power
supply
1.2. Power cord or plug is
defective
1.3. Other electrical defect to
the product
2.1. Extension cord not
suitable for operation
with this product
2.2. Power source (e.g.
generator) has too low
voltage
2.3. Air vents are blocked
3.1. Not connected to power
supply
3.2. Saw blade is worn or
damaged
3.3. Bevel and mitre angle
incorrectly adjusted
4.1. Dull / damaged saw
blade
4.2. Cutting angle is incorrect
4.3. Saw blade not suitable
for work piece material
4.4. Overheated saw blade
4.5. Workpiece not clamped /
placed properly
5.1. Saw blade is dull/
damaged
5.2. Bolts/nuts are loose
MAN CWM 216/254 FR
Resolution
1.1. Connect to power supply
1.2. Check by a specialist
electrician
1.3. Check by a specialist
electrician
2.1. Use a proper extension
cord
2.2. Connect to another power
source
2.3. Clean the air vents
3.1. Connect to power supply
3.2. Replace with new one
3.3. Check and adjust
according to the
instruction manual
4.1. Replace with new one
4.2. Adjust the bevel and / or
mitre cutting angle
4.3. Use proper saw blade
4.4. Let the work cool down
before using again
4.5. Clamp / place the
workpiece properly before
cutting
5.1. Replace with a new one
5.2. Tighten bolts/nuts
21
Publicité
Table des Matières
