Cooper Lighting Solutions Metalux FP Instructions page 3

N ote: This fixture is compatible with 0-10V dimming.
If installing dimming wires follow your dimmer
instructions for wiring to the violet (Dim +) and grey
(Dim –) leads.
This fixture is compatible with battery backup
N ote:
systems including the Surelites EBPLED7W and
EBPLED14W. If using a battery backup system
remove driver cover plate to access LED load wires
and follow battery backup wiring instructions
(Figure 5). Ensure driver cover plate is reinstalled
after wiring.
8. Tuck all wires and wire nuts into the fixture junction
box, replace electrical access plate, and snap securely
into place. (Figure 6.)
Figure 6.
Additional Instructions for Models With
Selectable Lumens and Selectable Color
9. With fixture powered on, use the lumen switch and
CCT switch (if equipped) to adjust the fixture to the
desired lumen level and CCT (Figure 7). Refer to label
on top of driver for lumens and wattage of each setting.
Figure 7.
10. (Optional) Once desired lumen level and CCT have been
selected, attach provided switch cover securely using
provided screws to prevent these settings from being
changed, if desired. (Figure 8.)
Figure 8.
11. To clean fixture, use a small amount of water on a cloth
and wipe the lens. Do not use chemicals on the lens as
this could cause damage.
12. Turn breaker on. Use wall switch to verify light turns on.
COOPER LIGHTING SOLUTIONS
FP Panel Instructions
IB519107EN Installation instructions
3