Charging The Battery; Fitting The Battery - Hilti SID 14­A Mode D'emploi

6.2 Charging the battery

DANGER
Only used the specified Hilti battery packs and Hilti battery chargers
which are listed under "Accessories".
6.2.1 Charging a new battery for the first time
Charge the battery fully before using it for the first time.
6.2.2 Charging a previously used battery
Ensure that the outer surfaces of the battery are clean and dry before
inserting it in the corresponding charger.
Read the operating instructions for the charger for further information about
the charging procedure.
Lithium-ion battery packs are ready to use at any time, even when only
partially charged. Charging progress is indicated by the LED display (see
charger operating instructions).

6.3 Fitting the battery

CAUTION
Before fitting the battery, check that the power tool is switched off and
that the safety lock is engaged (forward/reverse switch in the middle
position). Use only the Hilti batteries approved for use with this power
tool.
CAUTION
Check that the terminals on the battery and in the power tool are free
from foreign objects before inserting the battery in the power tool.
1. Push the battery into the power tool from the rear as far as it will go and
until it is heard to engage with a double click.
2. CAUTION If it is not fitted securely, the battery could fall out while
you are working with the tool.
CAUTION A falling battery may present a risk of injury to yourself or
others.
Before beginning the work, check that the battery is fitted securely to
the tool.
Printed: 19.09.2013 | Doc-Nr: PUB / 5070694 / 000 / 02
en
15