Hilti SID 14­A Mode D'emploi page 17

e) Improve the blood circulation in your fingers by relaxing your hands
and exercising your fingers during breaks between working.
Avoid touching rotating parts. Switch the power tool on only after
f)
bringing it into position at the workpiece. Touching rotating parts,
especially rotating insert tools, may lead to injury.
g) Activate the safety lock (forward / reverse switch in the middle
en
position) before storing or transporting the power tool.
h) Children must be instructed not to play with the power tool.
i) The power tool is not intended for use by children, by debilitated
persons or those who have received no instruction or training.
j) WARNING: Some dust created by grinding, sanding, cutting and
drilling contains chemicals known to cause cancer, birth defects,
infertility or other reproductive harm; or serious and permanent
respiratory or other injury. Some examples of these chemicals are:
lead from lead-based paints, crystalline silica from bricks, concrete
and other masonry products and natural stone, arsenic and chromium
from chemically-treated lumber. Your risk from these exposures varies,
depending on how often you do this type of work. To reduce exposure
to these chemicals, the operator and bystanders should work in a
well-ventilated area, work with approved safety equipment, such as
respiratory protection appropriate for the type of dust generated,
and designed to filter out microscopic particles and direct dust
away from the face and body. Avoid prolonged contact with dust.
Wear protective clothing and wash exposed areas with soap and
water. Allowing dust to get into your mouth, eyes, or to remain on your
skin may promote absorption of harmful chemicals.
5.2.2 Power tool use and care
a) Secure the workpiece. Use clamps or a vice to secure the work-
piece. The workpiece is thus held more securely than by hand and both
hands remain free to operate the power tool.
b) Check that the insert tools used are compatible with the chuck
system and that they are secured in the chuck correctly.
c) Ensure fastener and attachment will withstand the level of torque
generated by the tool.
damage the fastener/attachment and possibly lead to personal injury.
5.2.3 Cordless tool use and care
a) Ensure the switch is in the off position before inserting battery pack.
Inserting the battery pack into power tools that have the switch on invites
accidents.
12
Printed: 19.09.2013 | Doc-Nr: PUB / 5070694 / 000 / 02
Excessive torque may overstress, strip or