Before You Begin; Tools And Parts Needed; Parts Included; Power Requirements - Thermador Masterpiece Serie Guide D'installation

Before you begin

Tools and parts needed

Philips head screwdriver
▯
1/8" drill bit and drill
▯
Measuring tape
▯
Knife
▯

Parts included

Microwave oven
▯
Philips head screws
▯

Checklist for Installation

Use this checklist to verify that you have completed each
step of the installation process. This can help you avoid
mistakes.
Refer to detailed instructions for each step in the
sections following this checklist.
Before installing the appliance, be sure to verify the
1.
cabinet dimensions are correct for your appliance and
that the required electrical connections are present.
Make sure the electrical conduit provided on the
appliance is able to reach to the point of connection.
Section: Dimensions and Cabinet Requirements
Move the appliance into place in front of the cabinet
2.
opening.
Section: Removing Packaging

Removing Packaging

NOTICE: To prevent damage to your floor keep the unit
in its packaging base until ready to be placed in the
cabinet opening. Do not slide the unit across the flooring.
Different models use different packaging materials.
Bracket remains in packaging base.
Cut straps on outside of box, if present, remove
1.
staples and open the box top.
Lift out the accessories and manuals, close the box.
2.
Cut arround the dotted line near the base of the box.
3.
Lift off the box.
4.
Remove all top and side cardboard and Styrofoam
5.
braces.
Place oven in front of cabinets where it is to be
6.
installed.
NOTICE: To avoid damage to the microwave oven, do
not grip or use the door or door handle while the
microwave oven is being handled.
B e f o r e y o u b e g i n

Power Requirements

The outlet must be properly grounded in accordance with
all applicable codes.
It can be installed in the back wall directly behind the
appliance.
You can also connect your appliance directly to a
compatible conventional Built-in Oven. Refer to separate
Combination Instructions.
Remove packaging materials, leaving the bottom
3.
packaging on the appliance to avoid damage to the
floor.
Section: Removing Packaging
Team-lift the appliance directly into the cabinet cutout.
4.
Section: Install Appliance, "Mount to Cabinet"
Slide the appliance all the way into place.
5.
Section: Install Appliance, "Mount to Cabinet"
Fasten the appliance to the cabinet opening with the
6.
screws supplied.
Section: Install Appliance, "Mount to Cabinet"
Always read and follow the complete installation
instructions contained in this manual.
7