Makita DC40RA Manuel D'instructions page 7

You can mount the charger on the wall. Make a clearance around the charger as shown in the figure.
► Fig.4
NOTE: Things you need to prepare:
— Two screws - hanging the charger
Screw size : 4.0 mm x more than 20 mm.
Screw head size : Less than ø9.0 mm and less than 3.5 mm thickness.
— One screw (4.0 mm x more than 25 mm) - for anchoring the charger.
— Tools - for tightening screws
1. Fix two screws for hanging on the wall.
2. Hang the charger on the wall using the hook on the back.
► Fig.5
3. Fix the charger by tightening an anchor screw at the top of the charger.
► Fig.6
7 ENGLISH