Makita DC40RA Manuel D'instructions page 6

NOTE: If the charging light flashes slowly in blue color, charging may not start due to the condition of the battery
cartridge as below:
— Battery cartridge from just-operated tool or battery cartridge that has been left in a location exposed to direct
sunlight for a long time.
— Battery cartridge that has been left for a long time in a location exposed to cold air.
NOTE: When the battery cartridge is too hot, charging does not begin until the battery cartridge temperature
reaches the degree at which charging is possible.
NOTE: If the charging light changes to red color, charging is not possible. The terminals on the charger or battery
cartridge are clogged with dust or the battery cartridge is worn out or damaged.
Changing melody upon completion of charging
1. Inserting the battery cartridge into charger brings out last preset brief melody sound of completed charging.
2. Removing and re-inserting it within five seconds after this action makes the melody sound change.
3. Every time removing and re-inserting it within another five seconds after this, the melody sound changes in
order.
4. When the desired melody sound comes out, leave the battery cartridge being inserted and the charge will
begin. When a "short beep" mode is selected, no completed charging signals comes out. (Silent Mode)
5. With finish of charge, the charging light will light up in green and the melody sound preset at the insertion of
battery cartridge or buzzer sound (a long beep) comes out to notify completion of charge. (In selected silent
mode, no sounds come out.)
6. Preset melody sound remains stored even when the charger is unplugged.
Cooling system
This charger is equipped with cooling fan for heated
battery in order to enable the battery to prove its own
performance. Sound of cooling air comes out during
cooling, which means no trouble on the charger.
Blue and red light will flash alternately for warning in the
following cases.
• Trouble on cooling fan
• Incomplete cool down of battery, such as, being
clogged with dust
The battery can be charged in spite of the alternate blue
and red light. But the charging time will be longer than
usual in this case. Check the sound of cooling fan, vent
Wall mounting
WARNING:
Make sure to use two screws for hanging the charger on the wall, and anchor the charger
on the wall with another screw. Otherwise the charger may fall and cause serious injury.
WARNING:
Always be sure that the charger is unplugged and the battery is removed from the charger
before performing wall mounting work.
WARNING:
Follow the steps instructed in this manual, and complete the whole procedures at once.
The charger may fall and cause injury or damage if you stop the work in the half way.
WARNING:
Check tightness of the screws on regular basis. Otherwise the charger may fall because of
loosen screw.
WARNING:
Clean the terminal parts of the charger on regular basis with an air duster etc.
CAUTION:
Carefully choose a stable wall for mounting the charger. Make sure there is no hindrance
to mounting work or charging operation. The gross weight of the charger and battery reach approximately
2.1 kg (4.6 lbs). Provide sufficient reinforcement for the wall if necessary.
on the charger and battery, which can be sometime
clogged with dust.
Always keep clean the vent on charger and battery for
cooling.
► Fig.3: 1. Exhaust vent 2. Intake vent
NOTE: The cooling system is in order although no
sound of cooling fan comes out, if the blue and red
light will not flash.
NOTE: The products should be sent to repair or
maintenance, if the blue and red light flashes alter-
nately so often.
6 ENGLISH