Luminance Brands Kathy Ireland Home KEANE Manuel Du Propriétaire page 7

3. Ceiling Fan Assembly
3.7
Route the Two Motor Wires through the Hanger Ball
(Figure 7) .
Reinstall the Hanger Ball on the Downrod as follows:
Position the Pin through the Two Holes in the Downrod
and align the Hanger Ball so the Pin is captured in the
Groove in the top of the Hanger Ball (Figure 7) .
Pull the Hanger Ball up tight against the Pin and
securely retighten the Phillips Head Set Screw in the
Hanger Ball (Figure 7) .
A loose Phillips Head Set Screw could create Fan
wobble .
3.8
The Fan comes with Black and White Wires that are
80-inches long .
Measure up approximately 6 to 9-inches above top of
Hanger Ball / 4 .5" Downrod Assembly (Figure 8) .
Cut off excess Wires and strip back insulation 1/2-inch
from end of Wires .
(Continued)
4.5" DOWNROD
PHILLIPS HEAD
SET SCREW
Figure 7
1/2-INCH
6 TO 9
INCHES
Figure 8
7
PIN
HANGER BALL
BLACK WIRE
WHITE WIRE
HANGER BALL
luminancebrands.com
Please contact 1-800-777-4440 for further assistance
ETL Model No.: CF320