Luminance Brands Kathy Ireland Home KEANE Manuel Du Propriétaire page 6

3. Ceiling Fan Assembly
3.4
Align the Clevis Pin Holes in the Downrod with the
Holes in the Motor Coupler .
Install the Clevis Pin and secure with the Hairpin Clip
(Figure 4) .
The Clevis Pin must go through the Holes in the Motor
Coupler . It is critical that the Clevis Pin in the Motor
Coupler is properly installed and securely tightened .
Retighten the Two Phillips Head Set Screws to secure
the Downrod to the Motor (Figure 4) .
WARNING
!
It is critical that the clevis pin and set screws in the
motor coupler are properly installed and securely
tightened. Failure to verify that the pin and set screws
are properly installed could result in the fan falling.
3.5
Make sure the Grommet is properly installed in the
Coupler Cover, then slide the Coupler Cover on the
Downrod until it rests on the Motor Housing (Figure 5) .
3.6
Place the Ceiling Cover over the Downrod (Figure 6) .
Be sure that the Ceiling Cover and the Coupler Cover
are both oriented correctly (Figure 6) .
(Continued)
HAIRPIN
CLIP
CLEVIS
PIN
CLEVIS
PIN
RETIGHTEN
PHILLIPS HEAD
SET SCREW (2)
Figure 4
COUPLER COVER
COUPLING COVER
GROMMET
GROMMET
Figure 5
Figure 6
6
MOTOR
MOTOR
COUPLER
COUPLING
HAIRPIN
CLIP
4.5" DOWNROD
COUPLING
COUPLER
COVER
COVER
MOTOR
HOUSING
CEILING
COVER
4.5" DOWNROD
ETL Model No.: CF320