DeFelsko PosiTector 6000 Guide Rapide page 2

The PosiTector 6000 powers-up when the center navigation
button is pressed. To preserve battery life, the instrument
powers down after approximately 5 minutes of no activity. All
settings are retained.
1. Remove the protective rubber cap (if supplied) from probe.
2. Power-up Gage by pressing the center navigation
3. Place the probe FLAT on the surface to be measured. HOLD
STEADY. When a valid measurement is calculated, the Gage
BEEPS twice and the measurement is displayed.
4. Lift probe AT LEAST 2 INCHES (5cm) from the surface between
measurements - OR - leave probe on the surface in the same
location for continuous measurements.
Gage functions are menu controlled. To access the Menu, power-
up the gage, then press the center navigation button.
Navigation Button
Up
Center
Down
NOTE:
The center
eliminate unintentional powering-up of the gage.
Introduction
Introduction
Quick Start
Quick Start
Menu Operation
Menu Operation
To navigate, use the Up and Down buttons to
scroll and
Select Exit to exit from any menu.
button is purposely recessed to help
1
to SELECT.
button.