DeFelsko PosiTector 6000 Guide Rapide page 10

Masquer les pouces Voir aussi pour PosiTector 6000:

Les langues disponibles

Before returning the instrument for service...

1.Install new or newly recharged batteries in the proper alignment

as shown within battery compartment.

2.Examine the probe tip for dirt or damage. The probe should

move up and down freely.

3.Perform a Hard Reset (pg. 5).

4.Place a plastic shim onto bare metal (steel or non-ferrous metal,

depending upon whether you have an "F " or "N " probe) and

attempt a measurement.

If you must return the Gage for service, describe the problem fully

and include measurement results, if any. Be sure to also include

the probe, your company name, company contact, telephone

number and fax number or email address.

Website: www.defelsko.com/support

Limited Warranty, Sole Remedy

DeFelsko's sole warranty, remedy, and liability are the express

limited warranty, remedy, and limited liability that are set forth on

its website: www.defelsko.com/terms

or part, by any means, without written permission from DeFelsko Corporation.

DeFelsko and PosiTector are trademarks of DeFelsko Corporation registered in the U.S. and in other

countries. Other brand or product names are trademarks or registered trademarks of their respective

holders.

Every effort has been made to ensure that the information in this manual is accurate. DeFelsko is not

responsible for printing or clerical errors.

Returning for Service

and Limited Liability

www.defelsko.com