CAPITAL SPORTS Pacemaker F100 Mode D'emploi page 45

Belt Adjustment
The running belt is pre-adjusted to the running deck at the factory, but after
prolonged use it can stretch and require readjustment. To adjust the belt,
turn on the main power switch of the treadmill and let the belt run at a speed
of 8-10 KPH. Use the 6 mm Allen Wrench provided to turn the rear roller
adjustment bolts in order to centre the belt.
If the running belt is shifting to the left, turn the left adjustment bolt 1/4
turn clockwise, and the running belt should start to correct itself.
If the running belt is shifting to the right, then turn the right adjustment bolt
1/4 turn clockwise, and the belt should start to correct itself. Keep turning
the adjustment bolts until the running belt is properly centered.
EN
45